VIDEO OF THIS RACK  BEING INSTALLED HERE
https://youtu.be/mfSZkKQ8DtE
 
With Gutter channel widths of 1360mm at the front and 1320mm at the rear, The Tough Touring Gutter mount roof top tent rack  rail is secured by 4 Gutter mounts each side  - Running off a 1 piece gutter rail that extends the length of the 80's roof. 
The Top edge of the rail is folded outwards - The Unique Outfold  allows Easy removal of tents, (And fitting of roof top tents that are typically 1350mm or wider )  our low mount Top Hat Bar planks can be ordered in 1400, 1450, or 1550mm Widths to handle even the largest RTT on the market.
The Top hat bar planks allow Easy tool access from beside the vehicle, making it easy tofitted and remove the tent when not in use  .
 
For Some Roof top tents such as the Tuff Trek Mk3 and the Bullett tent, The Rack can optioned as a Stand alone Roof rails kit, (Saving Height and Money ) - As these tents can be fitted without any cross bars.

Refinements have led to an overall One piece foot rail height of 115mm - resulting in a plank resting height of under 20mm over the high point on the roof. VERY LOW.
 
The Roof rail takes away point load issues with traditional gutter mount roof racks, securing immense loads stronger and lower.  
 
Warranted to carry roof loads of up to 300Kgs Off road - . 
Minimum Rack width 1450mm - 2100 Long, ID 1260mm - Ideally Using our standard kit, /  Gutter widths measured at 1360mm Front with 1320 mm at the rear . 
 
The Gutter clamps do not foul on the 80's doors like many others - With many installs Sitting just 15mm - 20mm  off the high point on the roof - 
 
 
These Roof racks are reccmmended to be used in conjuntion with our Awning to TENT brackets, should you wish to install a Pole Less awning to your set up.